GREAT PLANES Riot 3D Instruction Manual page 8

❏
3. Center the bottom wing in the wing saddle area as
shown using the same measuring technique as the stabilizer.
It may assist you to mark the centerline on the fuselage and
bottom wing with a felt-tip pen. Mark on the wing where it
meets the fuselage. Trim the covering inside the marks, and
then, glue the wing in place using medium CA. Be very
careful not to cut into the balsa.
❏
4. Locate the two wing struts and center cabane. There
are slots in the top of the bottom wing, and the bottom of the
top wing for these wing struts to slide into. Carefully remove
the covering from these slots using a sharp hobby knife.
❏
5. Test fit the wing struts and center cabane as shown in
the photos above. Glue the wing struts in place as shown
using medium CA. Note the direction of the wing struts.
Insure the struts are parallel to the fuse.
❏
6. Test fit the the top wing on the struts and center
cabane. Glue the top wing to the wing struts using medium
CA. Check that the top wing is parallel to the bottom wing.
8