Rear Combination Lights - Mitsubishi MIRAGE Service Manual

Replacement of light bulbs
4. Turn the bulb (E) counterclockwise to
remove it.
5. To install the bulb, perform the removal
9
steps in reverse.
NOTE
 When refitting each of the clips, first insert
part (F) of the clip into the hole and then
press part (G) into it.
9-30 Vehicle care and maintenance

Rear combination lights

1. Open the liftgate.
(Refer to "Liftgate" on page 5-27.)
2. Remove the screws (A) that hold the light
unit.
3. Move the light unit toward the rear of the
vehicle to unfix the notch (B) and pin (C).
I n f o r ma t i o n P r o v i d e d b y :
4. Turn the socket counterclockwise to
remove it.
N00943700490
D- Back-up light
E- Rear turn signal light
F- Rear side-marker light, and tail and
stop light
5. Remove the bulb from the socket by turn-
ing it counterclockwise while pressing in.