Jack And Tools - Mitsubishi MIRAGE Service Manual

10. Replace the radiator cap and tighten it
fully. Check the coolant temperature
warning light. You can start driving again
when the high coolant temperature warn-
ing light does not come on.
11. Have the system inspected by your autho-
rized Mitsubishi Motors dealer or a repair
facility of your choice.

Jack and tools

Storage
The tools are stored beneath the floor board
of the cargo area. The jack (if so equipped) is
stored under the driver's seat.
Type A
Type B
N00836600379
1- Tools
2- Jack (if so equipped)
Tools
1- Tools bag
2- Wheel nut wrench
I n f o r ma t i o n P r o v i d e d b y :
Jack and tools
3- Jack bar
4- Towing hook
Jack
(if so equipped)
Before removing or storing the jack, move
the driver's seat fully forward to access the
jack from the rear seat area.
(Refer to "Front seat" on page 4-3.)
CAUTION
 Never access, remove or store the jack from
the front of the driver's seat. Doing so could
damage electrical wires under the driver's
seat.
To remove
Turn the shaft end of the jack in the direction
(1) until the jack fully retracts and remove the
jack from the holder (A).
To store
Put the jack in the holder (A) and turn the
shaft end of the jack in the direction (2) by
hand until the jack is firmly secured.
For emergencies
8
8-5