Rear Combination Lights - Mitsubishi i-MiEV 2017 Owner's Manual

D- Front turn signal light
E- Front fog light
F- Daytime running light
4. Remove the bulb as follows.
[Front turn signal light]
Pull the bulb out of the socket.
[Front fog light and daytime running
light]
While holding down the tab (G), pull out
the bulb assembly (H).
Front turn signal light
Front fog light
Daytime running light
5. To install the bulb, perform the removal
steps in reverse.
CAUTION
 Handle halogen light bulb with care. The gas
inside a halogen light bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen light bulb can cause it to shatter.
Replacement of light bulbs
CAUTION
 Never hold the halogen light bulb with a bare
hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the fog lights are used.
If the glass surface is dirty, clean it with
alcohol and let it dry completely before
installing the bulb.

Rear combination lights

1. Open the liftgate.
(Refer to "Liftgate" on page 5-11.)
2. Remove the screws (A) that hold the light
unit and remove the light unit.
Vehicle care and maintenance
9
N00943700487
9-25