Brake Fluid; Battery - Mitsubishi MIRAGE Service Manual

Hide thumbs Also See for MIRAGE:
Table of Contents

Advertisement

Brake fluid

Brake fluid
To check the fluid level
The fluid level must be between the "MAX"
and "MIN" marks on the reservoir.
MAX
9
MIN
The fluid level falls slightly with wear of the
brake pads, but this does not indicate any
abnormality.
The fluid in the master cylinder should be
checked when doing other work under the
engine hood. The brake system should also be
checked for leaks at the same time.
If the fluid level falls noticeably in a short
length of time, it indicates leaks from the
brake system.
9-10
Vehicle care and maintenance
If this occurs, have the vehicle checked by an
authorized Mitsubishi Motors dealer or a
N00938700274
repair facility of your choice.
Fluid type
Use the brake fluid conforming to DOT 3 or
DOT 4. The reservoir cap must be tightly
sealed to keep dirt and water out.
CAUTION
 Do not let any petroleum-based fluid touch,
mix with, or get into the brake fluid. This
will damage the seals.
 Be careful when handling brake fluid. It can
damage painted surfaces.
 Use only the listed brake fluid. Different
brands of brake fluid have different addi-
tives, and these can cause a chemical reac-
tion. Do not mix brands of brake fluid.
 Keep the reservoir tank cap closed to keep
the brake fluid from evaporating.

Battery

The condition of the battery is very important
for quick starting and to keep the vehicle's
electrical system working properly. Check the
battery regularly.
I n f o r ma t i o n P r o v i d e d b y :
Checking battery electrolyte
level
The electrolyte level must be between the
limits shown on the outside of the battery. Fill
it with distilled water as needed. The inside of
the battery is divided into several compart-
ments. Take the cap off of each compartment
and fill to the mark.
Do not fill above the top line because a spill
during driving could cause damage.
WARNING
 If the battery goes flat, be sure to check
N00939100943
the battery electrolyte level before con-
necting booster cables.
 After checking the battery electrolyte
level, make sure the caps are fitted
securely.
N00901500072

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents