Handling Of Compact Discs - Mitsubishi MIRAGE Service Manual

Handling of compact discs

Error display
USB BUS PWR
LSI ERROR
Handling of compact discs
7  Use only the type of compact discs that
have the mark shown in the illustration
below. (Playback of CD-R or CD-RW
discs may cause problems.)
 The use of special shaped, damaged com-
pact discs (like cracked discs) or low-
quality compact discs (like warped discs
or burrs on the discs) such as those shown
will damage the CD player.
7-40 Comfort controls
Item
An overcurrent or other power-supply error has
occurred.
Internal device errors
N00734100340
 In the following circumstances, moisture
can form on compact discs and inside the
audio system, preventing normal opera-
tion.
Remove the USB memory device.
Have the vehicle inspected at an authorized Mitsubishi
Motors dealer or a repair facility of your choice.
Have the vehicle inspected at an authorized Mitsubishi
Motors dealer or a repair facility of your choice.
I n f o r ma t i o n P r o v i d e d b y :
Repair
• When there is high humidity (for exam-
ple, when it is raining).
• When the temperature suddenly rises,
such as right after the heater is turned on
in cold weather.
In this case, wait until the moisture has
had time to dry out.
 When the CD player is subjected to vio-
lent vibrations, such as during off-road
driving, the tracking may not work.
 When storing compact discs, always store
them in their separate cases. Never place
compact discs in direct sunlight, or in any
place where the temperature or humidity
is high.
 Never touch the flat surface of the disc
where there isn't a label. This will damage
the disc surface and could affect the sound
quality. When handling a compact disc,
always hold it by the outer edge and the
center hole.