Password Information; Error Responses; Using The Command And Response Tables - Extron electronics SMP 351 User Manual

Password Information

The ]
Password:
a carriage return. The prompt is repeated if the correct password is not entered.
If the correct password is entered, the unit responds with ]
]
Login User
administrator and user, the unit will default to administrator privileges.

Error Responses

When the SMP 351 is unable to execute the command, it returns an error response to the
host. The error response codes and their descriptions are as follows:
E10 – Unrecognized command
E12 – Invalid port number
E13 – Invalid parameter (number is out of
range)
E14 – Not valid for this configuration
E17 – Invalid command for signal type

Using the Command and Response Tables

The Command and Response Tables
represent variables in the command and response fields. Command and response examples
are shown throughout the table. The SIS commands are not case sensitive. The ASCII to
HEX conversion table below is for use with the command and response table.
Space
Figure 94.
prompt requires a password (administrator level or user level) followed by
] , depending on the password entered. If passwords are the same for both
ASCII to Hex Conversion Table
ASCII to Hex Conversion Table
SMP 351 • Remote Communication and Control
Login Administrator
E18 – System timed out
E22 – Busy
E24 – Privilege violation
E26 – Maximum connections
exceeded
E28 – Bad file name or file not
found
begin on page 164. Symbols used in the table
•
] or
160