Assigning Functions To Assignable Buttons/Switch - Sony SRW-9000 Operation Manual

VF
The viewfinder connected to the VF connector
(default ON)
HDY
A monitor connected to the TEST OUT or
REMOTE connector. This setting is enabled
when TEST[SIG] or RM[SIG] has been set to
HD-Y in the <MONITOR OUTPUT> page of the
Camera >USER (OPERATION) menu (default
ON).
MON
A monitor connected to the HD SDI MON1 or
HD SDI MON2 connector (default ON)
VBS
A monitor connected to the TEST OUT or
REMOTE connector (default ON)
Assigning Functions to
Assignable Buttons/Switch
You can assign functions to the following
buttons/switch: assignable buttons 1 to 3 and 5 to
8 on the right-side panel of the main unit and the
AP-1 (optional); the 4 side (top) of the 4/AUTO
BLK BAL switch (called "switch 4" below) and
assignable buttons N and C.
The following functions are assigned when the
unit is shipped from the factory.
Switch Function
1 OFF (no function)
2 OFF (no function)
3 OFF (no function)
4 OFF (no function)
5 STOP
6 PLAY
7 REW
8 F.FWD
N
OFF (no function)
C
OFF (no function)
a) ND is assigned when the optional HKSR-9004 is
installed
b) CC is assigned when the optional HKSR-9004 is
installed
50 Basic Settings with the Subdisplay
Functions that can be assigned to assignable
buttons 1 to 3, 5 to 8, N, and C
Menu indication
REC REVIEW
PB(VF/VBS)
MLUT
FAN MODE
VTR SAVE
BARS
STOP
REW
PLAY
F.FWD
GAIN
WHITE BAL
ND
CC
OFF
a) When using the RGB 4:4:4 format with the optional
HKSR-9003 installed
Functions that can be assigned to assignable
a)
switch 4
b)
Menu indication
AWB
BARS
TEST1
OFF
Note
Even if AWB is assigned to assignable switch 4, AWB
does not function in Cine mode.
Function
With REC REVIEW set to
NORM, the last part of the
recorded tape is normally
rewound for 3 seconds
(maximum: 10 seconds) then
played back. With REC
REVIEW set to ALL, the tape
is rewound to the recording
start position then played
back.
The video signals being
played back are output to the
viewfinder.
a) On/Off of the fixed ITU-R709
gamma of the viewfinder and
the monitor
Switching of the fan mode
Switching of the VTR power
supply mode (SAVE, STBY)
Display color bars
Stop tape transport
Rewind the tape
Play the tape
Fast forward the tape
Switch the gain position
Switch the white balance
memory
Switch ND filters (when the
optional HKSR-9004 is
installed)
Switch CC filters (when the
optional HKSR-9004 is
installed)
None
Function
Automatic white balance
adjustment
Color-bar indication
Test signal output
None