Table of Contents
Advertisement
3-2-8 Confirmation of the Power
Voltage and Selection of Fan
Operation Mode
The values in voltage of the power sources connected to
the camera can be confirmed on the subdisplay.
On the same page, the operation mode of the built-in fans
can also be selected.
Voltage confirmation/Fan Operation mode select
page
1
11.4V
FAN:AUTO1
At 1 and 2 on the first line, the values in voltage of the
12-V and 24-V power systems are displayed, respectively.
If power is not supplied, "- -" is displayed.
If the voltage falls to the NEAR END level, the indication
starts flashing. If the voltage falls further down to the END
level, the indication flashes rapidly.
The NEAR END and END levels can be set on the <BATT
ALARM SET> page of the MAINTENANCE menu.
On the second line, Fan Operation mode can be changed.
Setting
Operation of the fans
AUTO1 (default)
The fans are automatically controlled
according to the internal temperature.
Normally use this mode.
AUTO2
In synchronization with recording, the
fans are controlled for the quietest
condition.
As the rotation speed will increase if the
internal temperature rises, use other
modes for recording that may continue
several tens of minutes.
MIN
The quietest fan operation is
maintained.
Use this mode for long recording at
ordinary temperatures.
MAX
The fans rotate at the maximum speed
to lower the internal temperature.
3-2-9 ON/OFF of the Character
Indication
Superimposition of character data onto camera images can
be activated or deactivated by output destination.
2
24.1V
Character indication setting page
VF1:ON
MON:ON
VF1
Viewfinder connected via the VF1 connector (default: ON)
VF2
Viewfinder connected via the VF2 connector (default: ON)
MON
Monitors connected via the MONITOR OUT HD SDI
connectors (default: ON)
VBS
Monitors connected via the TEST OUT and REMOTE
connectors (default: ON)
3-2-10 Allocation of Functions to
the Assignable Buttons and Switch
Various functions can be allocated to assignable buttons 1
to 3 and assignable switch 4 (the upper position of the 4/
AUTO BLK BAL switch) that are located on the side of the
camera and on the assistant panel.
At shipment, no function is allocated to these buttons.
Functions that can be allocated to assignable
buttons 1 to 3
Menu
Function
indication
ND
Selection of the ND filter
REC REVIEW
With REC REVIEW set to NORM on the
SRW-1, the last part of the recorded tape
is normally rewound for 3 seconds
(maximum: 10 seconds) then played
back.
With REC REVIEW set to ALL on the
SRW-1, the tape is rewound to the
recording start position then played back.
PB(VF)
The video signals being played back on
the SRW-1 are output to the viewfinder.
VF709GAM
ON/OFF of the fixed ITU-R709 gamma of
the viewfinder
MONI709GAM
ON/OFF of the fixed ITU-R709 gamma of
the monitor
FAN MODE
Switching of Fan Operation mode
VF2:ON
VBS:ON
Basic Settings with the Subdisplay
35
Advertisement
Table of Contents
