Shift Lever; Hydraulic Brake System - Arctic Cat Prowler XTZ 2009 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983

Shift Lever

CHECKING SHIFT LEVER CABLE
Set the parking brake and turn the ignition switch on;
then with the shift lever in the neutral position, look
for the (N) indication on the LCD. Shift into high
range and look for the (H) indication, low range for the
(L) indication, and reverse for the (R) indication. Shift
the transmission into neutral and turn the ignition
switch off.
ADJUSTING SHIFT LEVER CABLE
To adjust the shift lever cable, use the following proce-
dure.
1. Set the parking brake; then remove the seats and
center console.
2. Make sure the shift lever is in neutral; then remove
the E-clip securing the cable end to the shaft arm.
3. Loosen nuts (A) and (B) and adjust the cable hous-
ing to align the throttle cable end to the shift arm
stud (C).
www.mymowerparts.com
Back
2-10
PR571
PR567A
Back to TOC
4. Install the E-clip; then tighten the nuts (A) and (B)
securely.
5. Check each gear shift position for proper gear selec-
tion and make sure the proper icon illuminates on
the LCD; then install the center console and seats.

Hydraulic Brake System

NOTE: This vehicle is equipped with four-wheel
disc brakes. The following procedure is for both
front and rear brakes.
CHECKING/BLEEDING
The hydraulic brake system has been filled and bled at
the factory. To check and/or bleed a hydraulic brake
system, use the following procedure.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the
reservoir is not above the MIN, add DOT 4 brake
fluid.
Back to Section TOC
PR568A
PR572A
Next