Running Setup - Symbol PDT 3400 Series Product Reference Manual

PDT 3400 Product Reference Guide

Running Setup

To run Setup:
1. Boot the PDT 3400 by pressing and holding the PWR button for 12 seconds or the
value specified in Setup.
2. During the boot process, press the Scan Bar when the PDT 3400 displays the prompt:
3. Press and hold the Scan Bar when the PDT 3400 displays the message:
until Setup displays the screen shown in Figure 8-1:
a. To change the BIOS settings, press the Scan Bar with STANDARD highlighted
and proceed to step 4.
b. To reset the BIOS to the default settings, scroll down to DEFAULT using
press the Scan Bar. The default settings are provided in Default Configuration
Parameters in this chapter for reference.
c. To exit the Setup screen, scroll down to EXIT using
4. If you selected STANDARD, the Main Menu (Figure 8-2) is displayed:
8-2
Trig Skips Test
Trig Runs Setup
SETUP
STANDARD
DEFAULT
EXIT
Figure 8-1. BIOS Setup Screen
MAIN MENU
TIME 00 :00:00
DATE 01/01/96
CONTRAST
KEYCLICK
SUSPEND
RESET
BOOT SEQ
Figure 8-2. BIOS Setup Main Menu
1.0
ê
and press the Scan Bar.
3
ON
30
12
C
ê
and