Wall Mounting The Crd 3400 - Symbol PDT 3400 Series Product Reference Manual

PDT 3400 Product Reference Guide

Wall Mounting the CRD 3400

The back housing of the CRD 3400 also serves as a wall mounting bracket. To mount the
CRD 3400 on a wall:
1. Position the cradle's back housing against the wall and mark the top hole's position
(Figure 3-4). Remove the back housing.
Figure 3-4. Positioning the CRD 3400 for Wall Mounting
2. Insert the appropriate type of screw for the wall into the marked hole and fasten for
position. Do not tighten yet.
3. Feed the communications and power cables through the back housing and connect
to the ports as directed in steps 1-3 for Desk Mounting the CRD 3400 on page 3-3.
4. Place the back housing on the wall over the top screw installed in step 2 and tighten
the screw to secure.
5. Insert the two additional screws and tighten to secure.
6. Slide the cradle's front housing over the "hook" at the top of the back housing.
7. Press the front housing against the snaps in the back housing's base to secure.
8. Connect the cables to the host as described in Connecting the Cradle(s) to the Host.
3-4
Mounting
Holes