Symbol PDT 3400 Series Product Reference Manual page 85

OR on the toolbar, choose the Send button.
Note: TCM checks the script and builds the image, if the timestamp changed
since the last build, before preparing to send the resulting hex file. To
transfer the hex file without performing these steps again, select
Transmit from the File Menu. The steps for Transmit are the same as
for Send.
3. TCM checks for a connection to the PDT 3400 and waits for IPL on the PDT 3400.
4. Go to the section IPL Setup.
Setup for Download Using HEX2TERM
HEX2TERM is a MS-DOS utility which can be used in place of TCM for transferring hex
files from a PC to the PDT 3400. The hex file can be either a BIOS update or a ROM disk
image.
To run HEX2TERM:
1. On the development PC, type:
HEX2TERM filename [baud] [port]
where:
filename
[baud]
[port]
The default COMM parameters are as follows:
9600 baud
COM1
8-bit data
no parity
Xon/Xoff flow control
2. Go to IPL Setup.
Terminal Configuration: Building and Sending the Hex Image
Specifies the name of the hex file being transferred to the PDT 3400.
Is the baud rate. The baud rate defaults to 9600. Possible values are
2400, 4800, 9600, 19200, 38400, 57600, or 115200 (default).
Is the COM port designation: COM1 (default) or COM2.
6-27