Load Stacker (Mount The Compressed Volume(S)) - Symbol PDT 3400 Series Product Reference Manual

PDT 3400 Product Reference Guide

2. Load Stacker (Mount the Compressed Volume(s))

If the drive you created is not mounted, modify CONFIG.SYS as follows to load Stacker as
a device driver:
DEVICE=C:\STACKER\DPMS.EXE
DEVICE=C:\STACKER\STACKER.COM
The STACKER.INI file is used by device driver STACKER.COM when loaded in
CONFIG.SYS. If necessary, edit STACKER.INI to add or modify lines.
Note: STACKER.INI may be set with DOS attributes of hidden, system,
and read-only. To see this file via DOS's DIR command, use the /AH
switch.
To modify the file's attributes so it can be edited with a standard text editor, use the DOS
ATTRIB command with the following command line:
ATTRIB -R -S -H C:\STACKER.INI
Once the modification is complete, use the command line above with +R, +S, and +H to
append the attributes back to the file.
After loading Stacker (via CONFIG.SYS) and setting STACKER.INI properly, reboot your
development PC for a proper setup. Then use the following command line to find out what
drive letters Stacker assigned to your compressed drives:
STACKER
Stacker displays information similar to the following:
Stacker drive map:
Drive A was drive A at boot time
Drive B was drive B at boot time
Drive C was drive C at boot time
Drive D was drive D at boot time
Drive E was drive E at boot time
Drive F was drive F at boot time [C:\STACVOL.46C = 0.5MB]
2-6