Glass Platen; Slit Glass - Kyocera KM-3050 Operation Manual

Slit Glass

OPERATION GUIDE

Glass Platen

If black streaks or
dirt appears in
copies when using
the optional
document
processor, clean the
slit glass with the
supplied cleaning
cloth. The message
Clean the slit glass.
may be displayed if
the slit glass
requires cleaning.
IMPORTANT: Lightly wipe the slit glass with a dry cloth. To remove
adhesive material or ink, apply alcohol to a cloth and wipe lightly. Do not
use water, thinner, or organic solvents.
1
Remove the cloth from the cleaning cloth compartment.
2
Open the document processor
and wipe the slit glass (a).
3
Press [End].
Clean the slit glass.
03/14
Hold
Status
a
Maintenance
1.Open the document processor.
2.Clean the surface of the slit glass located on
the left side and the reading guide on
the document processor with the supplied
dry cloth.
3.Close the document processor.
4.Press [End].
Note that dirty glass and sheet may cause
black streaks to appear in the output.
End
10/5/2006 10:10
5-3