Troubleshooting - Chelsio T5 Installation And User Manual

Chapter III. SMBDirect
v. Using Get-NetAdapter command, verify if the virtual switch is created successfully. The
Mac address of the switch and the port on which the switch was created, should be same.
vi. Enable RDMA on the virtual switch using Enable-NetAdapterRdma command.
vii. Run Get-NetAdapterRdma command to verify if RDMA is enabled on the switch.
2.4.

Troubleshooting

If RDMA is not working in your system, please check for the following:

Operating system version should be Windows Server Technical Preview 3 or Server 2012
R2.

Verify network interface configurations on both sides.

Please ensure that the interfaces are reachable using ping command.

In the Event Viewer (on the client side), please ensure that the traffic running is not over
TCP.
Chelsio T5/T4 Unified Wire for Windows 71