Chelsio T5 Installation And User Manual page 141

Chapter V. Unified Wire Manager (UM)
8.6.4. iWARP
iWARP Settings
On Linux Agents, iWARP parameter settings for Chelsio's RDMA capable NICs can be set using
this module. These settings can be set only when iWARP driver (iw_cxgb4 for T4 and T5;
iw_cxgb3 for T3) is loaded. If you set any parameter for a T5 adapter, it applies for all the T5
adapters present. Same applies for T4 and T3 adapters.
On Windows Agents, only T3 HBAs are supported currently. Parameters can be set per port.
On FreeBSD Agents, only T4 CNAs are supported. iWARP parameter settings can be set only
when iw_cxgbe driver is loaded.
Chelsio T5/T4 Unified Wire for Windows 141