BodyCraft GXP Assembly Instruction Manual page 8

STEP 2 ASSEMBLE CABLE ARM ASSEMBLY
Remember to keep all BOLTS loose to ensure the holes will align easily.
1. Attach the Cable Arm Assembly (17) to the threaded bolts welded on the bottom of the
Main Frame (1) using two 1/2" Smaller Washers (136) and two 1/2" Nylon Nuts (144).
2. Attach Cable Arm Assembly (17) to Cable Arm Connector (18), using two 3/8" X 1" Hex
Threaded Bolts (112) and two 3/8" Washers (137) then attach Cable Arm Connector
(18) to Main
Smaller
3. Insert the axle
plates on the
Collars (33).
Collars (33).
freely and
Frame (1), using one 1/2" X 3" Hex Bolt (104) and one 1/2"
Washer (136).
of each Cable Arm (15) into the holes of the axle
Cable Arm Assembly (17) and the fasten using the
Tighten the 5/16" X 1/4" Set Screws (133) on the
Check to ensure that both Cable Arms (15) pivot
cables are not twisted.
136
1
7
17
133
33
33
144
144
136
104
4
15
18
137 112
32
136
137
112
32
15