BodyCraft GXP Assembly Instruction Manual page 17

STEP 9 WEIGHT STACK SHROUD & ACRYLIC PANEL
ASSEMBLY IS COMPLETE !
Tighten all bolts, starting with main frame bolts on the base, and work way to top.
1. Attach Weight Stack Shroud (39R , 39L) to the tabs welded on Base Frame (1) and Top
Frame (2) as shown, using four 5/16" X 1/2" Screws (117) and four 5/16" Washers
(138).
2. Attach R & L Acrylic Panel (40R, 40L) to the threaded tube welded on the Main Frame
(1), using four M6 X 70L Round Screws (125) and four Plastic Studs (93).
DO NOT OVER TIGHTEN THE SCREWS! CRACKED PANELS DUE TO OVER
TIGHTENING ARE NOT COVERED UNDER WARRANTY!
3. Attach Top Side Panel (41R , 41L) and Top Side Metal Trims (44) to the threaded tube
welded on the top of the Main Frame (1), using four M6 X 12L Flat Pin Bolt (124). DO
NOT OVER TIGHTEN THE SCREWS! CRACKED PANELS DUE TO OVER
TIGHTENING ARE NOT COVERED UNDER WARRANTY!
4. Attach Press Arm Panel (64) to Press Arm (7) using four M6 X 12L Male Screws (124).
5. Attach Pulley Cover Panel (42) on the rear top of Main Frame (1), using four M6 X 12L
Male Screws (124).
6. Attach Lat Bar (37), Curl Bar (36), Single Handle (50) and AB Crunch Belt (48) to the
GXP Strength Training System.
16