Table of Contents
Advertisement
Assembly is complete! Please take the following steps before using the gym:
1.
Make certain all bolts are tightened securely.
2.
Make certain all cables are seated into all pulley grooves. A cable rubbing
against steel will peel the nylon coating, voiding warranty and resulting in
a need for replacement.
3.
Pre-stretch the cables. Put the Weight Selector Pin (59) in the bottom hole on
the weight stack. Pull on the cables with great force, helping remove any kinks
and providing any initial cable stretch.
4.
Be aware the cables can loosen and slightly stretch upon initial use.
5.
The cables should be adjusted as tight as possible, but no so tight as to lift the
Top Plate (46) above the weight stack. Be certain to secure the jam nuts after
adjustments are made.
6.
For better performance, apply a household lubricant (such as silicone) to
any adjustable areas and to the Guide Rods (6).
7.
Enjoy many years of a Fit Lifestyle.
Thank you for purchasing the BodyCraft GXP Strength Training
System. If you have any questions, please call your local
BodyCraft dealer, call our customer service department at
800-990-5556 or at http://www.bodycraft.com.
Hide quick links:
Advertisement
Chapters
Table of Contents
