BodyCraft GXP Assembly Instruction Manual page 16

STEP 8 INSTALL CABLE ARM CABLE
Ball End
1. The Cable Arm Cable (69) is already run through the Cable Arm (15). Mount Pulley P3 and
P7 along with their Pulley Guide Brackets (26) to the Cable Arm Assembly (17) as shown,
using one 3/8" X 1-3/4" Hex Bolt (109) and one 3/8" Nylon Nut (145). Route the cable over
top of these pulleys. Tighten these nuts, making sure the Pulley Guide Brackets (26) do not
rub against the cable.
2. Continue routing, on both sides, down and around pulleys P4 and P6 mounted to the base
of the Cable Arm Assembly (17) using one Pulley Guide Bracket (26), one 3/8" X 5-3/4" Hex
Bolt (107), and one 3/8" Nylon Nut (145) for each side. Tighten these nuts, making sure the
Pulley Guide Brackets (26) do
3. Route the cable up to
Block (23) that is
P5
P9
P8
P7
P6
P4
CABLE ARM CABLE (69)
not rub against the cable.
dangling at the end of the Connect Cable (69). Install
107
137
26
P6
P2
P3
P1
pulley P5 mounted inside the Adj Floating Pulley
145
15
17
P2
76
P3
P1
26
P1,P2,P3
109
17
P3
76
76
26
P4
145
137
P4,P6
15
Ball End
pulley using one 3/8" X
30.5L Flat Pin Bolt (122)
and one M6 X 12L Male
Screw (124).
23
76
124
26 76
17
145
109
17
P8
P9
P8,P9
122
P5
15
P7