Chroma 62000H Series Operating & Programming Manual page 71

M A S T E R O R S L A V E
M / S T E R M I N A T O R
P A R A L L E L O R S E R I E S
N U M .
M A S T E R & S L A V E C O N T R O L =
Press " " to confirm.
ENTER
3.
Press " " to return to the MAIN PAGE.
EXIT
4.
Take example by 62150H-600S:
1.
2.
3.
4.
3.3.3.3.5 Activating MASTER & SLAVE CONTROL
When PARALLEL OR SERIES, NUM. OF SLAVE are set for MASTER, it is able to use
MASTER to activate the series/parallel control as described below:
1. Use " ", "
shows.
2. Use the numeric (
M A S T E R O R S L A V E
M / S T E R M I N A T O R
P A R A L L E L O R S E R I E S
N U M .
M A S T E R & S L A V E C O N T R O L =
O F S L A V E
Figure 3-43
If there are 5 sets connected in parallel and 600V/100A is set, the
setting of each set is 600V/20A and the total output will be
600V/100A.
If there are 2 sets connected in series and 1200V/25A is set, the
setting of each set is 600V/25A and the total output will be
1200V/25A.
The total sets for connecting in series are 2; therefore, the
maximum number of NUM. OF SLAVE is 1.
The total sets for connecting in parallel are 10; therefore, the
maximum number of NUM. OF SLAVE is 9.
" keys to move the cursor to the column to be set as Figure 3-44
1
) key or "Rotary" (
O F S L A V E
Figure 3-44
[ S E R I E S / P A R A L L E L ]
= M A S T E R
= D I S A B L E
= P A R A L L E L
= 4 _
N O
) knob to set YES。
[ S E R I E S / P A R A L L E L ]
= M A S T E R
= D I S A B L E
= P A R A L L E L
=
Y E S _
Manual Operation
4
3-29