Toshiba 2460 Service Handbook page 54

Notes 1. Wind the wire round the pulley taking the fol-
lowing precautions
• Never twist the wire when winding.
• Wind the wire tightly to make it come into
close contact with the pulley.
• Wind the wire taking care not to leave any
gap between the wraps.
2. When the wire holder jig is installed, do not
slide or loosen the wound wire.
3. The wire holder jigs are the same for the front
and rear sides.
Be careful when installing the jig.
The jigs will not installed if its installation di-
rection is wrong, it is floating on the pulley.
<Installation phase>
Spherical terminal
Pulley
September 1997 © TOSHIBA CORP.
In full contact
Example) Front side
←
Front side
Wire holder jig
1 - 51
→
Rear side
Projection
Wire holder jig
Projection
2460 ADJUSTMENT