Toshiba 2460 Service Handbook page 33

d) Registration
< Adjustment order >
Copier cassette
Lower Upper
(441) (440)
< Adjustment procedure >
(1) Make a test print as in the following procedure.
0 5
PWR
(2) Measure the distance "D" which is the distance to the 6th line from the leading edge of the
test print paper.
(3) In order to set the distance "D" to 52 mm, adjust as follows.
Code
Notes 1. An increase in the value corresponds to a decrease in the distance "D" (0.5 mm/step).
2. In order to make a test print, make sure the message indicates [ 100 %
after the INT key is pressed.
3. Adjustment value is able to be input within the range of 0 ~ 15. Default adjustment
value is 8.
In case of the lower cassette feeding (Code "441"), adjustment value is within the
range of 0~40 (Default adjustment value is 13).
4. Since the lower cassette adjustment value becomes a standard for all adjustments,
this adjustment must always be performed in the order stated above.
2460 ADJUSTMENT
Bypass
A A
(442)
1
FAX
Print movement direction
D
Set the value
START
LCF PFP
A
(443) (444)
INT
1 - 30 September 1997 © TOSHIBA CORP.
ADU
A
(445)
1
FAX
A ]