Toshiba 2460 Service Handbook page 35

b) CCD primary scanning deviation
(1) Place the scale (its end to the rear side original scale and its side to the left side original
scale) on the original glass and make an A4 100% copy.
(2) In order to correct the distance "E", which should be 100 mm from the position copied to the
bottom of the paper, adjust as follows.
0 5
PWR
Notes 1. An increase in the value makes the image shift to the paper edge (0.0423 mm/
step).
2. In order to make a test copy, make sure the message indicates [100 %
after the INT key is pressed.
3. Adjustment value is able to be input within the range of 5 ~ 251.
The default adjustment value is 85.
2460 ADJUSTMENT
Copy movement direction
3 0 6
START
E
Set the value
1 - 32 September 1997 © TOSHIBA CORP.
E/S
INT
(Test copy)
A]