Table of Contents
Advertisement
there is a radio signal present and is trying to receive it. When the time code is received,
the DCF tower becomes permanently lit and the time will be displayed.
If the tower icon flashes, but does not set the time or the DCF tower does not appear at all,
then please take note of the following:
1.
Recommended distance to any interfering sources like computer monitors or TV sets
is minimum of 1.5 to 2 meters.
2.
Within thick concrete rooms (basements, superstructures), the received signal is
naturally weakened. In extreme cases, please place the unit close to a window and/
or point its front or back towards the Frankfurt transmitter.
3.
During nighttime, the atmospheric disturbances are usually less severe and
reception is possible in most cases. A single daily reception is adequate to keep the
accuracy deviation below 1 second.
MANUAL SETTINGS
Press the "SET/CH" key about 2 seconds to enter the following manual setting modes:
1.
°C/°F Temperature setting
2.
12/24 Hour Time setting
3.
Manual time setting
4.
Calendar setting
°C/°F TEMPERATURE DISPLAY SETTING
The temperature display can be selected to show temperature data in °C or °F. (Default °C)
1.
The characters "ºC" or "ºF" will start flashing in LCD.
2.
Use the "MIN/MAX/+" key to select "ºC" for temperature reading in degrees Celsius
or "ºF" for temperature reading in degrees Fahrenheit.
3.
Press the "IN/OUT/SET/CH" key again to confirm and to enter the "12/24 Hour time
display setting".
12/24 HOUR TIME DISPLAY SETTING
Flashing
Flashing
Advertisement
Table of Contents
