Manual Settings; Lcd Contrast Setting; Time Zone Setting - La Crosse WS9251 Instruction Manual

* When the signal is successfully received by the weather station, the Outdoor reception icon will be
switched on. (If not successful, the icon will not be shown in LCD) So the user can easily see whether
the last reception was successful (icon on) or not (icon off). On the other hand, the flashing of the icon
shows that a reception is being done now.

MANUAL SETTINGS

The following settings can be changed when pressing the SET key:
•

LCD contrast setting

•

Time zone setting

•
Time reception (RCC) ON/OFF setting
•
Daylight saving time (DST) ON/OFF setting
•
Manual time setting
•
Calendar setting
Press and hold the SET key for about 2 seconds to advance to the setting mode:
LCD CONTRAST SETTING
The LCD contrast can be set within 8 levels, from LCD 0 to LCD 7 (Default is LCD 3):
1. Press and hold the SET key until the digit starts flashing.
2. Press the + key or MIN/MAX key to set the level of contrast desired.
3. Press the SET key to enter "Time Zone setting," or exit the setting mode by pressing the
ALARM key or SUN key.
TIME ZONE SETTING
The time zone setting is used for countries where DCF signal can be received but not in the same time
zone as the German time (e.g. 1h = one hour later.) The default time zone is "0h". To set a different time
zone:
1. The current time zone value starts flashing.
2. Use the + key to set the time zone. The range runs from -2 to +5 hour, in one-hour interval.
3. Press the SET key to enter "Time Reception On/Off setting," or exit the setting mode by
pressing ALARM key or SUN key.
Digit flashing
Flashing
27