Manual Settings; Lcd Contrast Setting - La Crosse 1910 Quick Setup Manual

* When the signal from the transmitter/ or Rain sensor (optional) is successfully received
by the Weather Station, the icon will be switched on. (If not successful, the
not be shown on the LCD). User can therefore easily see whether the last reception was
successful ("ON" icon) or not ("OFF"
the icon shows that a reception is being done at that time.
* In normal display user may press the SET key shortly to toggle between Mode1 and
Mode 2 display:
Mode 1 : Wind speed, outdoor temperature, relative air pressure are shown.
Outdoor temp
icon
In Mode 1, this reception icon is showing the condition of the
reception of the signal from Thermo-hygro transmitter
icon will
icon). On the other hand, the short blinking of
Wind speed icon
Rel. Air Pressure icon
9
Mode 2 : Wind gust, dew point, and rainfall (optional) reading are shown.
Note: To view the rainfall data, press the + key after entering Mode 2 display.
Dew point icon

MANUAL SETTINGS:

The following manual settings can be changed once the SET key is pressed and held for
about 3 seconds:


LCD contrast setting


Manual time setting

12/24 hour time display

Calendar setting

°C/ °F temperature unit setting

Wind speed unit

Rainfall unit setting

Air pressure unit setting

Relative pressure reference value setting

Weather tendency threshold value

Storm warning threshold value

Alarm On/ Off setting
LCD CONTRAST SETTING
Wind gust icon
Rainfall icon
In Mode 2, this reception
icon is showing the
condition of the reception
of the signal from Rain
sensor (only if a rain
sensor is being used)
Digit flashing
10