Table of Contents
Advertisement
Note: Should after checking the above list an outdoor temperature is still not received, then
reset all the units.
THERMO-HYGRO TRANSMITTER (optional):
The temperature and humidity are measured every 1 minute and transmitted every 1
minute. The range of the Thermo-Hygro transmitter may be affected by temperature. At
cold temperatures the transmitting distance may be decreased. Please bear this in mind
when placing the transmitter.
POSITIONING THE WEATHER STATION:
The Weather Station comes complete with a detachable stand that
gives the option of table standing or wall mounting. To wall mount:
1.
Fix a screw into the desired wall, leaving the head extended out
by about 5mm.
2.
Using the Weather Station's hanging hole, carefully hang it onto
the screw.
Note: Always ensures that the unit locks onto the screw head before
releasing.
POSITIONING THE OUTDOOR TEMPERATURE TRANSMITTER (optional)
The Thermo-Hygro transmitter is supplied with two screws for wall mounting. Before
securing the transmitter, ensure that the 433MHz signal (outdoor temperature and relative
humidity readings) is properly received.
etc.). Before securing in place, please ensure that the Weather station can receive the
signal from the Thermo-Hygro transmitter at the positions that you wish to situate them.
CARE AND MAINTENANCE:
•
Avoid placing the units in areas prone to vibration and shock as these may cause
damage.
•
Avoid areas where the units can be exposed to sudden changes in temperature, i.e.
direct sunlight, extreme cold and wet/moist conditions as these will lead to rapid
changes in temperature which reduces the accuracy of readings.
•
When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents
or scouring agents.
•
Do not submerge the units into water.
•
Immediately remove all low powered batteries to avoid leakage and damage.
Replace only with new batteries of the recommended size.
The mounting surface can affect the
transmission range. If e.g. the unit is
attached to a piece of metal, it may then
either reduce or increase the transmitting
range. For this reason, we recommend not
placing the unit on any metal surfaces or in
any position where a large metal or highly
polished surface is in the immediate
proximity (garage doors, double glazing
Advertisement
Table of Contents
