Installing The Front Mounting Screws - IBM 2104 Model DS4 Installation Manual

CAUTION:
The stabilizer must be correctly attached to the bottom front of the rack to
prevent the rack from tipping forward while the 2104 Model DS4 is being
installed into the rack. Do not remove or install any unit if a stabilizer is not
attached to the rack. (9)
Note: If you are going to install the 2104 Model DS4 into a Model T00 or T42 rack,
Perform the following steps to install the 2104 Model DS4 into the rack:
1. If you have not already done so, remove all of the disk drive modules from the
2. Stand at the front of the rack. With help from another person, place the back of
3. Install the two front mounting screws 1 and tighten them. See Figure 26.
Figure 26. Installing the front mounting screws
12
Expandable Storage Plus 2104 Model DS4 Installation Guide
you must also observe the safety notices for those racks before you start.
You can find the safety notices in the system installation chapter of the 7014
Model T00 and T42 Rack Installation and Service Guide, SA38-0577, or at
the following Web site:
www-1.ibm.com/servers/eserver/pseries/library/
hardware_docs/sa38/380577.pdf
2104 Model DS4. For more information, see "Removing the disk drive modules
and dummy disk drive modules" on page 5.
the 2104 Model DS4 onto the support rails. Slide the 2104 Model DS4 into the
rack.
SC000284