Table of Contents
Advertisement
Connecting the 2104 Model DS4 to the host system
Perform the following steps to connect the 2104 Model DS4 to the host system:
1. Refer to the 2104 Model DS4 configuration information and check how the 2104
2. Attach identification labels to the external SCSI signal cables. For details, see
3. Plug the SCSI signal cables into the connectors 1 on the SCSI interface
Figure 43. Plug in the SCSI signal cable
4. Attention:
Model DS4 is to be connected to the host system. Go to "Valid configurations"
on page 35 to verify your configuration.
the appropriate adapters, devices, and cables information manual.
cards. See Figure 43.
Do not use a power-driven screwdriver.
Tighten the retaining screws 2 . You might need a small screwdriver to do this.
SC000003
Installing a 2104 Model DS4
29
Advertisement
Table of Contents
