Installing The Switch Cover Plate; Installing The Switch Cover Plate Onto The Panel Of The Scsi Interface Card-2 - IBM 2104 Model DS4 Installation Manual

Expandable storage plus
Table of Contents

Advertisement

Installing the switch cover plate

Note: Switch configuration is only valid on the SCSI interface card-1, which is on
Figure 31. Installing the switch cover plate onto the panel of the SCSI Interface card-2
(second JBOD interface card) box
Perform the following steps to install the switch cover plate onto the panel of the
SCSI Interface card-2 (second JBOD interface card).
Note: If the switch cover plate is already installed, you do not need to perform step
1. Locate the hook, latch, and pins. See Figure 32 on page 18.
the left side (left side from the rear view). The configuration on the SCSI
interface card-2, which is on the right side, is ignored. The switch cover plate
is on card-2 so that it can be masked. See Figure 31. You must place the
SCSI interface card in the left side from the rear view in a single SCSI
interface card configuration. See JBOD 1 in Figure 31.
CAR
UNIT ID
OPTION
SWITCH
5
4
3
2 1
CARD
SW Cover added on 2nd JBOD card
Switch Cover plate
JBOD 2
JBOD 1
OPTION
UNIT ID
SWITCH
5
4
3
2 1
1 through step 3 on page 18.
SC000277
Installing a 2104 Model DS4
17

Advertisement

Table of Contents
loading

Table of Contents