Table of Contents
Advertisement
4. While you continue to push the disk drive module into the slot, slowly close the
handle 1 until it stops with a click. See Figure 29. This action pushes the
module fully home.
Figure 29. Closing the handle of a disk drive module
5. Verify that the disk drive module that you have just installed is aligned with the
sides of the 2104 Model DS4 and that no gap exists between this module and
the modules that are next to it.
Verify also that the front edge of this disk drive module aligns with the front
edges of the modules that are next to it.
If the disk drive module is not correctly aligned, remove it (see "Removing the
disk drive modules and dummy disk drive modules" on page 5). Repeat step 1
on page 14 through step 4 to reinstall the disk drive module.
6. Repeat step 1 through step 5 for each disk drive module.
Attention: Any slot that has no disk drive module installed must contain a
dummy disk drive module. The dummy disk drive module ensures that the
correct airflow is maintained around the disk drive modules in the other slots.
SC000926
Installing a 2104 Model DS4
15
Advertisement
Table of Contents
