Working With The Spraygun; Starting Up The Spraygun - WAGNER PEM-C2 Operating Manual

3.

Working with the spraygun

3.1

Starting up the spraygun

•
Switch on the control unit.
•
Make the necessary basic settings on the control unit.
•
Check on the control unit whether the atomizing air is opened on pressing the trigger.
As a result the deflector cone remains free from powder deposits and the cascade
chamber is flushed.
•
Refer to the operating instructions of the control unit for this.
To reduce wear, the total of feeding air and dosage air must range between
4 - 6 Nm
Caution
•
Hold the spraygun in the spray booth, press the trigger and set the powder volume and
the powder speed to a test piece by adjusting the volume of feeding air and dosage air.
•
You can alter the size of the powder cloud during powdering by adjusting the atomizing air.
The following illustration provides information on the effects of the feeding and dosage air
volume on the powder volume.
feeding air
volume
An exact description of how to set the air flows can be found in the operating instructions for
the corresponding control units.
feeding air
volume
02/01
PEM-C2
3 3
/h (141.2 - 211.8 ft /h)!
dosage air
volume
+
+
+
dosage air volume
(feeding air volume + dosage air volume + powder volume)
powder hose inner diameter
powder suction from the powder tank
feeding volume
=
=
=
total feeding volume to the spraygun
12
0351801