Multifunction Switch Settings (Fig. 4, A); Setting The Flow Rate When Working With The Spray Lance (Fig. 4, B); Setting The Width Of The Spray Jet On The Spray Lance (Fig. 5) - WAGNER 2361555 Manual

GB D
12.
Multifunction switch settings (fig.
FILL/ Settings for cleaning and
CLEAN pre-filling the system
OFF System is off
ON Operating setting
When using the spray
i
attachment for varnish paints
and glazes, the FILL/CLEAN
functions may not be used!
13. Setting the flow rate when working with the spray
lance (fig. 4, B)
The material quantity is set depending on the characteristics of the material (viscosity)
and the working speed of the operator.
This setting can be made variably with the material flow limiter:
lower material
higher material
We recommend starting with a low material flow setting and then gradually
i
adjusting this to suit needs. .
14. Setting the width of the spray jet on the spray lance
(Fig. 5)
A = wide spray jet
(black)
B = narrow spray
jet (white)
42 42
turn to the left
turn to the right
For coating larger surfaces
Working with a large flow
rate (black area on quantity
scale)
For coating smaller areas,
corners and edges
Working with a small flow
rate (white area on quantity
scale)
W 950 Flexio W 950 Flexio
4, A)
Volume
A
A
B
B