WAGNER PEM-C2 Operating Manual page 7

For your own safety, use only accessories and equipment listed in the
operating manual. The use of individual parts other than those
recommended in the operating manual may create a hazard to personal
Warning
safety.
Use only original Wagner replacement parts!
Electrostatic arcing may cause an explosion or
fire. Mixtures of powder and air can explode or
ignite causing property damage and/or severe
injury.
Explosion or fire. Mixtures of powder and air
can explode or ignite causing property damage
and/or severe injury.
Toxic Substances: Some materials may be
harmful if swallowed or come in contact with
the skin.
02/01
HAZARD
PEM-C2
•
Operator must be grounded. Grounding straps must be
used when wearing rubber soled shoes.
•
Operator must be in contact with the spraygun handle; cut
out palm section and trigger fingers of any work gloves to
be used.
•
Operator must remove all metallic objects from his or her
person, which are not grounded.
•
The object being sprayed must be grounded.
•
All metallic objects within the spray area must be
grounded (including spray booth, part hangers, fire
extinguishers, etc.)
•
Grounded conductive floor must be provided in spray area.
•
Turn off the Power Pack and unplug from outlet before
flushing out the gun, cleaning or replacing parts on the gun
such as changing tips.
•
Exhaust and fresh air introduction must be provided to
keep the air within the spray area free of accumulation of
flammable atmosphere.
•
Smoking must not be allowed in spray area.
•
Fire extinguishing equipment must be present and in
working order.
•
Electrostatic arcing must be prevented. (See Electrostatic
arcing)
•
When cleaning
recommended by the coatings manufacturer. Be sure
Power Pack is turned off and unplugged.
•
Avoid all ignition sources such as static electricity sparks,
open flames such as pilot lights, hot objects such as
cigarettes and sparks from connecting and disconnecting
power cords and working light switches.
•
To prevent hazardous concentrations of flammable
atmospheres, spray only in a properly ventilated spray
booth.
•
Never operate spraygun unless ventilation fans are
operating properly.
•
Check and follow all National, State and Local codes
regarding air exhaust velocity requirements.
•
Ventilation must be maintained during the cleaning
operation.
•
Follow the requirements of the Material Safety Data Sheet
supplied by the coatings manufacturer.
•
Exhaust and fresh air introduction must be provided within
the spray area to keep the air free of high powder
accumulations.
•
Wear a mask or respirator. Read all instructions for the
mask to insure that it will provide the necessary protection
against the inhalation of powder.
7
PREVENTION
the system, use only materials
0351801