WAGNER PEM-C2 Operating Manual page 2

Powder Spraygun PEM-C2
A Electrode
B Deflector cone
C Outer nut
D Spraygun body
The powder spraygun PEM-C2 is used for industrial powder coating.
This spraygun can be operated with the following control units:
•
EPG 2007
•
EPG Digiflow
The high voltage in the spraygun is activated by pressing the trigger. At the same time, the
powder and compressed air supplies to the gun are turned on.
The
Wagner equipment!
High ambient temperatures must be avoided; in particular, the hoses must not
Caution
be routed through factory areas exposed to direct sunlight!
To provide a safeguard against unintentional use of the spraygun, the control
unit must be turned off!
Powders containing metal pigments may only be processed in compliance with
the powder manufacturer's instructions.
02/01
PEM-C2
C
B
A
with powder injector
with powder injector
user must ensure,
E
D
E Trigger
F Atomizing air supply
G Powder supply
H Power supply
that the spraygun
2
Part No. 0351 021
F
G
H
PJ 2020 PRS
PJ-D1
is only connected to
0351801