Configuring The Advanced Discovery Settings - Honeywell MAXPRO Operator's Manual

Configuring the Advanced Discovery Settings

MAXPRO NVR 3.1 Operator's Guide
Live/Recording Quality can be varied by controlling GOP . The formula for this is calculated
as follows: Recording Quality resulting FPS = Live FPS/(GOP*I Frame Number for
recording).
For example, in the following table if Live FPS is configured as "30" and Continuous
recording is set to record "Every I frame" and Event recording is set to "Same as Live" with
GOP value set to "5", the result is 6 FPS continuous recording quality and 30 FPS event
recording quality.
Note:
GOP value below 5 may not be achieved from all the cameras.
9. Under Recording Deletion Settings
• Select the Event Recording clip deletion duration.
• Select the Continuous Recording clip deletion duration.
Caution:
For Recording Deletion Settings, please exercise caution with Keep
Forever clip deletion duration setting. Recordings with Keep Forever are
stored permanently and are not deleted/overwritten even if the disk
becomes full. They can be deleted only manually from the Search tab.
10. Under Audio Settings, select the check box to enable audio.
Note:
1-way audio (camera to NVR) is supported for specific IP cameras. Please refer to
the compatibility list on HOTA for the models supported.
11. Click Save.
The Advanced Discovery Settings enable you to set the video format (NTSC/PAL), username
and password of a camera as it is being added to the NVR from the Discovery window. The
Username and Password set for the camera in MAXPRO NVR must match the username and
password on the camera (actual device) to stream video into MAXPRO NVR.
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
79