Discovering And Adding Multi-Channel Encoders - Honeywell MAXPRO Operator's Manual

C O N F I G U R I N G M A X P R O N V R
4
Configuring the Cameras
Note:
5.

Discovering and Adding Multi-channel Encoders

An Encoder connects to an analog camera using a coaxial cable and converts analog video
streams to digital video streams, which can be sent over an IP network.
Each encoder varies based on the number of channels (cameras) supported. Please visit the
following URL:
encoders supported by MAXPRO NVR.
MAXPRO NVR automatically discovers its supported encoders and displays them in the
Discovery window as shown in the following figure.
Figure 4-7
The encoder is discovered as a single device in the Discovery window, and "n" number of
cameras (where n is the number of channels supported by the encoder) are added under
Camera as shown in the following figure.
82
For streaming to start, camera Advanced Settings in NVR (Resolution and FPS)
should be set to match the values supported by the camera/encoder.
Click Save.
http://www.security.honeywell.com/hota/
Encoder discovery
for the most up to date list of
MAXPRO NVR 3.1 Operator's Guide