Configuring A Site Using Ciu 888 Service Tool; Preparation - Honeywell CIU 888 Configuration Manual

Part No.: 4417584_Rev12
Getting Started

3.2 Configuring a site using CIU 888 Service Tool

The first step in configuration of CIU 888 is the creation of a site using
CIU 888 Service Tool. After a new site is created, the program prompts
for a set of global settings. Global settings are the overall configuration
settings applicable at a site level, see section 3.2.3 for more details.
Global settings are required for initiating any site configuration.
After the site global settings are entered, CIU 888 Service Tool prompts
for CIU 888 name and then CIU 888 Service Tool creates a site
configuration.
A site gives an overview of the configuration at a specific customer's
site. The site configuration can be saved offline and opened at a later
point in time. Selecting a site gives you access to its configuration.
When the site is not available in the list, a new site must be created.

3.2.1 Preparation

Before you start configuring CIU 888, certain preparations are
necessary. Make sure the following information is available:
Site layout

Field cabling information (which gauges are connected on the

same pair of field wires, etc.)
Tag names of field devices (gauges, CIU and tanks).

Tank information (strapping tables, or tank capacity tables, roof

details, etc.)
Information on the types of stored product

Host communication setup

Modbus TCP/IP Communication set up

Configuration Manual
CIU 888 3 - 23