Honeywell MAXPRO Operator's Manual page 74

C O N F I G U R I N G M A X P R O N V R
4
Configuring the Disk Management Settings
Caution:
Note:
5.
Note:
Caution:
6.
Note:
74
• In the Recording recycle at box, type a value. The Recording recycle refers to a
state when the oldest video recordings are automatically deleted, if there is no disk
space on the drives for new video recordings.
• In the Low disk alarm at box, type a value. The Low disk alarm refers to a state when
the space on the drives for video storage is nearing the maximum size of the drives.
The Low disk alarm at value must be always greater than the Recording
recycle at value.
Click Refresh to refresh the information under Disk Space at any point in time.
Click Add Drive to add a fixed drive or a network drive.
• The fixed drive that you are adding must be available on the MAXPRO NVR system,
else an "Invalid Drive" text displays in the Total Space (GB) column.
• Add a network drive in the following format: \\<IP address >\<folder name> for
example, \\192.168.1.12\Recorded Clips.
The Network drive added must be valid with proper folder permissions set for the
installed default user, else an "Invalid Drive" text displays in the Total Space
(GB) column.
Please exercise caution while using a network drive as a video storage
drive since network interruptions and network performance can lead to
loss of video recordings.
Click Save to save the information or click Reset to clear the information entered.
To remove a drive, select the check box corresponding to the drive, and then
click Delete.
MAXPRO NVR 3.1 Operator's Guide