KYMCO Agility 125 Service Manual page 143

12
. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
Drive new top and bottom ball races into the
steering head using the outer driver.
＊
Be sure to completely drive in the ball
races.
INSTALLATION
Apply grease to the top and bottom ball races
and install 26 steel balls on the top ball race
and 29 steel balls on the bottom ball race.
Apply grease to the ball races and install the
front fork.
Apply grease to the top cone race and install
it.
Tighten the top cone race and then turn the
steering stem right and left several times to
make steel balls contact each other closely.
＊
Check that the steering stem rotates
freely without vertical play.
Install the steering stem lock nut and tighten
it while holding the top cone race.
Torque: 6.0～8.0kgf-m
Install the front wheel. ( 12-7)
Install the steering handlebar. ( 12-3)
Install the speedometer cable. ( 12-7)
Special
Long Socket Wrench,32mm 8Angle
Driver Handle A
Outer Driver, 37x40mm
Top Cone Race
Long Socket Wrench
Lock Nut Wrench
AGILITY 125
Steel Balls
12-22