KYMCO Agility 125 Service Manual page 124

12
. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
STEERING HANDLEBAR
REMOVAL
Remove the handlebar front and rear covers.
( 2-2)
Remove the two bolts attaching each of the
front and rear brake levers.
Remove the front and rear brake levers.
Remove the two throttle holder screws and
throttle holder.
Disconnect the throttle cable from the throttle
pipe and then remove the throttle pipe from
the handlebar.
Remove the handlebar lock nut and bolt to
remove the handlebar.
INSTALLATION
Install the handlebar onto the steering stem
by aligning the tab on the handlebar with the
bolt orifice on the steering stem.
Install and tighten the handlebar bolt and lock
nut.
Torque: 4.5～5.5kgf-m
12-3
Bolts
Screws
Nut
Bolt Orifice
AGILITY 125
Bolts
Throttle Pipe
Throttle Cable
Bolt