Table of Contents
Advertisement
Rear View
DRAIN REQUIREMENTS
•
Use the new drain hose supplied with your dishwasher. If this is not long enough,
use a new drain hose with a maximum length of 10 ft (3.05 m) that meets all
current AHAM/IAPMO test standards, is resistant to heat and detergent, use
5/8"(1.58 cm) or 7/8"(2.2 cm) inside diameter (I.D.) hose and a coupler to connect
the two hose ends. Secure the connection with two clamps.
•
Dishwasher must be connected to waste line with an air gap (not supplied) or
32"(81.3 cm) minimum high drain loop, depending on local codes and ordinances
to prevent backflow into the dishwasher.
IMPORTANT: Failure to provide the proper drain connection height with air gap
or 32" (81.3 cm) minimum high drain loop will result in improper draining of the
dishwasher.
•
An air gap must be used if the waste tee or garbage disposal connection is less
than 20" (50.8 cm) above the floor to avoid backflow.
•
Use 1/2" minimum I.D. drain line fittings.
•
Do not connect drain lines from other devices to the dishwasher drain hose.
23⅞" (60.6 cm)
a
a
Air Gap
7
Advertisement
Table of Contents
