Table of Contents
Advertisement
STEP 6A- PREPARE CABINET OPENING USING
EXISTING UTILITY HOOKUPS
•
Follow the steps in this section if you are installing the dishwasher in an existing
cabinet opening with utility hookups.
•
If you are installing the dishwasher in a cabinet opening that does not have
hookups, follow the instructions under "Prepare Cabinet Opening Where there
are No Existing Utility Hookups" in Step 6B.
1. Check that the water line reaches to the front left of opening where the water
connection will be made.
2. Check that the direct wire reaches to the front right of opening where the
electrical connection will be made.
If the water line and the direct wire reach far enough
into the opening, proceed to the next section
"Install the drain hose." If they do not reach far
enough, follow the instructions under "Prepare
Cabinet Opening Where there are No Existing Utility
Hookups" in Step 6B.
INSTALL THE DRAIN HOSE
IMPORTANT:
•
Always use a new drain hose when installing a new replacement dishwasher.
•
Keep the drain hose away from the floor and the edge of the hole where it passes
through the cabinet to minimize the noise caused by vibration when using the
dishwasher.
1. Connect drain hose to waste tee or garbage disposal using one of the following
methods.
•
Option 1 – Garbage Disposal - With Air Gap
•
Option 2 – No Garbage Disposal- With Air Gap
•
Option 3 – Garbage Disposal - No Air Gap*
•
Option 4 – No Garbage Disposal - No Air Gap*
*an air gap is recommended
14
water
direct
line
wire
6" (15.2 cm)
Advertisement
Table of Contents
