Table of Contents
Advertisement
Method 2 - Power Supply Cord
IMPORTANT: A mating 3 prong, ground-type wall receptacle is required in a cabinet
next to the dishwasher opening.
1. Drill a 11/2" (3.8 cm) hole in the cabinet rear or side. Preferred and Optional
locations are shown in the following graphic.
2. Smooth edges of hole for power cord.
Wood Cabinet - Sand edges of hole until smooth.
Metal Cabinet - Cover edges of hole with grommet (not provided).
b
INSTALL THE WATERLINE
NOTE: Routing the water line through the left side of cabinet opening will make
water connection easier.
1. Drill a 1/2" (1.3 cm) hole in the cabinet side, rear or floor. Preferred and optional
locations are shown in the following graphic.
2. Measure to determine the overall length of copper tubing required for the water
line.
3. Attach copper tubing to the manual shutoff valve.
a
4. Slowly feed copper tubing through hole in cabinet. Copper tubing will bend and
kink easily, so be gentle. The copper tubing should be far enough into the cabinet
opening to connect it to the dishwasher inlet on the front left of the dishwasher.
5. Slowly turn water shutoff valve to "ON" position. Flush water into a shallow pan
to get rid of particles that may clog the inlet valve.
6. Turn shutoff valve to "OFF" position.
18
a
b
a
a
Preferred Locations
b
Optional Locations
a
Preferred Locations
b
Optional Locations
a
Copper Tubing
Advertisement
Table of Contents
