Table of Contents
Advertisement
1. Confirm that power is turned off at the source.
2. Remove terminal box cover. Retain for later use.
3. Install a UL listed/CSA approved strain relief.
4. Route power cord so that it does not touch dishwasher motor or lower part of
dishwasher tub.
5. Pull power cord through strain relief in terminal box.
a
6. Connect the wires as follows using UL listed wire nuts of the appropriate size to
connect power cord to 16-gauge dishwasher wire.
NOTES:
•
Use UL listed wire nuts of the appropriate size to connect
the power cord to 16-gauge dishwasher wiring.
•
Insert wire ends into twist on connector. Do not pre-twist
bare wire.
•
Twist connector.
•
Gently tug on wires to be sure both wires are secured.
a
7. Tighten strain relief screws to secure cord.
8. Reinstall terminal box cover with wire nuts inside terminal box.
9. Make sure wires are not pinched by cover.
Power supply wire:
white
black
ground wire
b
c
a
Strain Relief
Terminal box wire:
white
black
ground connector
a
b
c
Ground
White
Black
25
Advertisement
Table of Contents
