Step 15 - Secure Dishwasher - Haier HDBL865ATS Installation Instructions Manual

STEP 15 - SECURE DISHWASHER

Depending on the material of your countertop, use either instructions to "Install to
Countertop" or "Install to Adjacent Cabinets" to secure your dishwasher.
Install to Countertop
The dishwasher must be secured to the countertop using the two mounting clips on
top of the dishwasher.
1. Insert the mounting clips into the front, top slots of the dishwasher.
NOTE: The top mounting clips have a break off point, so a section of the clip can
be removed, if necessary, to fit the depth of the cabinet.
2. Open the dishwasher door and remove lower dish rack.
3. Place a towel over the pump assembly and spray arm of dishwasher to keep
screws from falling into pump area during installation.
4. Check that the dishwasher is level and centered side to side in the opening.
5. Check that the tub flange aligns with the front face of the cabinet frame.
6. Using two Phillips screws (provided), fasten the two mounting clips on the top of
the dishwasher to the underside of the countertop.
NOTE: The dishwasher must be attached to the countertop to keep it from
tipping when the door is opened.
7. Open the door about 3" (7.6 cm) and check that the space between the inner
door and tub is equal on both sides.
8. If spacing is not equal, loosen the mounting clip screws and shift the tub.
Retighten bracket screws.
9. Check that the top of the door does not contact the screws, mounting clips or
countertop. If it does, the dishwasher must be lowered and leveled again. See
"Level The Dishwasher."
10. If spacing is not equal, loosen the bracket screws and shift the tub. Retighten the
bracket screws.
28
a
b
c
a
#8 x 5/8" Phillips
Flat-Head Screw
a
a
Mounting Clips
b
Break Off Point
c
Tub Flange