Table of Contents
Advertisement
3. Select Rinse Only cycle; and press START/CANCEL.
4. After the first 2 minutes, unlatch door, wait 5 seconds, and then open door.
Check to see that there is water in the bottom of the dishwasher tub. Check that
dishwasher is working properly.
5. Check for leaks under the dishwasher. If a leak is found, turn power supply off,
then tighten connections. Restore power after leak is corrected.
6. Check for leaks around the door. A leak around the door could be caused by
door rubbing or hitting against adjacent cabinetry. Reposition the dishwasher, if
necessary.
7. When the dishwasher is draining, check the drain lines. If leaks are found, turn
power off at the breaker and correct plumbing as necessary. Restore power after
corrections are made.
8. Open dishwasher door and make sure most of the water has drained. If not,
check that disposal plug has been removed and/or air gap is not plugged. Also
check drain line for kinking.
9. Run the dishwasher through another Rinse Only cycle and drain.
STEP 18 – REPLACE THE KICK PLATE
1. Place the kick plate against the kick plate bracket. The slots should align with the
kick plate bracket screw holes. Allow the bottom edge of the lower kick plate to
touch the floor.
2. Fasten with the two kick plate screws.
32
Advertisement
Table of Contents
