WIRE ROUTING AND CONNECTION REQUIREMENTS
Cabinet Preparation and Wire Routing
•
Electrical connection is on the right front side of the dishwasher.
NOTE: Wiring the dishwasher will be easier if you route wire into the cabinet
opening from the right side.
•
The wiring may enter either from the right or left side, the rear or the floor within
the shaded area.
•
Wiring may pass through the same hole as the drain hose and hot water line or
cut an additional 11/2" (3.8 cm) dia. hole to admit the electrical cable.
NOTE: The hole must be free of sharp edges. If the cabinet wall is metal, the
edge of the hole must be covered with a bushing/grommet.
Electrical Connection to Dishwasher
Electrical connection is on the right front of dishwasher.
•
For direct wire connections the cable must be routed as shown in the following
graphic. Cable must extend a minimum of 24" (61 cm) from the rear wall.
•
For power cord connections, have a qualified electrician install a 3 prong
grounding type receptacle. The power-supply receptacle for the appliance shall
be installed in a cabinet or on a wall adjacent to the under counter space in which
the appliance is to be installed.
a
24" (61.0 cm)
minimum
from Wall
10
3" (7.6 cm)
from Cabinet
b
c d
a
Terminal Box
a
a
11/2" (3.8 cm) Dia. Hole (Max.)
b
Ground
c
Black
d
White